Ubiquiti RouterStation: Unterschied zwischen den Versionen
Aus Opennet
(Konfigurstionsdateien) |
(→Hardware) |
||
Zeile 4: | Zeile 4: | ||
=== Hardware === | === Hardware === | ||
+ | |||
+ | * MIPS-Architektur, Atheros AR71xx SoC | ||
+ | |||
+ | === Schnittstellen === | ||
+ | |||
+ | * eth0 = WAN-Schnittstelle (einzelner POE-Port) | ||
+ | * eth1 = LAN-Schnittstelle (2-Port-Switch) | ||
+ | * wifi0 = WLAN-Schnittstelle (SLOT_0 oben) | ||
+ | * wifi1 = WLAN-Schnittstelle (SLOT_1 oben) | ||
+ | * wifi2 = WLAN-Schnittstelle (SLOT_2 unten) | ||
+ | |||
+ | === Serial === | ||
+ | |||
+ | * 3.3 Volt (Level-Shifter notwendig) | ||
+ | * J3 (3-Pin Connector), Pinbelegung: | ||
+ | 2 - ORANGE (Signal IN/RX), | ||
+ | 5 - YELLOW (Signal OUT/TX), | ||
+ | 6 - BLACK (GROUND) | ||
== Erstinstallation == | == Erstinstallation == |
Version vom 28. Dezember 2009, 12:34 Uhr
MIPS Wireless Router Boards, siehe http://wiki.ubnt.com/wiki/index.php/RouterStation
Inhaltsverzeichnis |
Überblick
Hardware
- MIPS-Architektur, Atheros AR71xx SoC
Schnittstellen
- eth0 = WAN-Schnittstelle (einzelner POE-Port)
- eth1 = LAN-Schnittstelle (2-Port-Switch)
- wifi0 = WLAN-Schnittstelle (SLOT_0 oben)
- wifi1 = WLAN-Schnittstelle (SLOT_1 oben)
- wifi2 = WLAN-Schnittstelle (SLOT_2 unten)
Serial
- 3.3 Volt (Level-Shifter notwendig)
- J3 (3-Pin Connector), Pinbelegung:
2 - ORANGE (Signal IN/RX), 5 - YELLOW (Signal OUT/TX), 6 - BLACK (GROUND)
Erstinstallation
Hinweise siehe http://wiki.ubnt.com/wiki/index.php/RouterStation_OpenWRT_SW_Setup_Guide
Opennet Router
- /etc/config/network
config 'interface' 'loopback' option 'ifname' 'lo' option 'proto' 'static' option 'ipaddr' '127.0.0.1' option 'netmask' '255.0.0.0' config 'interface' 'wan' option 'ifname' 'eth0' option 'proto' 'dhcp' config 'interface' 'lan' option 'ifname' 'eth1' option 'proto' 'static' option 'ipaddr' '172.16.0.1' option 'netmask' '255.255.255.0'
- /etc/config/firewall
config defaults option syn_flood 1 option input ACCEPT option output ACCEPT option forward ACCEPT config zone option name lan option input ACCEPT option output ACCEPT option forward ACCEPT config zone option name wan option input REJECT option output ACCEPT option forward REJECT option masq 1 config forwarding option src lan option dest wan option mtu_fix 1 config include option path /etc/firewall.user